![]() ![]() IPS Empress 2/IPS Eris for E2 layering technique Preheating, pressing, and firing parameters (220 V) If the glaze of the ceramic surface is insufficient, a second glaze firing may be conducted. The IPS Empress 2 / IPS Eris for E2 layering technique requires a glaze firing.īasically, the following rule applies: the longer the holding time, the more pronounced is the lustre. Regional differences in the power supply or the operation of several electronic devices by means of the same circuit may render adjustments of the firing and press temperatu- res necessary. If a non-Ivoclar Vivadent furnace is used, temperature cor- rections may be necessary. ![]() If one of these furnaces is used, however, the tem- peratures may deviate by ± 10 ☌/18 ☏, depending on the age and type of the heating muffle. The temperatures indicated alsoĪpply to furnaces of older generations, such as the P20, P90, and P95. These firing parameters represent standard values applicable to the P80, P100, and PX1 furnaces from Ivoclar Vivadent. Note: Preheat with AlOx plunger, but without ingots. Please observe the Instruction for Use of the IPS Empress 2 Special Investment Material or IPS Empress 2 Speed Investment Material. Firing parameters for the Programat furnace (220 V)įiring parameters for IPS Eris for E2 Foundation firingįiring parameters for IPS Eris for E2 Dentin, incisal, and Impulse material firingįiring parameters IPS Empress Universal Shade/Stainsįiring parameters IPS Empress Universal Glazeįiring parameters for IPS Eris for E2 Corrective firing (add-on material) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |